Solar Home Battery Application
This is an application page, not a product page. It describes solar home storage in general terms, using the company's general application titles as its boundary. It does not present a solar-home-specific model beyond the home battery packs already listed on this site, and it does not give a capacity recommendation for a particular house.
How solar and home storage work together
In a solar home system, solar panels generate energy during the day, the home uses some of that energy directly, and a battery pack stores the remainder for use at night or during cloudy periods. The pack's voltage must match the home system, and its capacity must be considered alongside the solar array size and the household's daily energy use. A pack that is too small for the daily load will cycle deeply every day, while a pack that is far larger than the load will rarely be used fully. Both cases affect how the pack should be sized, which is why the sizing guide on this site asks about load and solar input together.
The home battery packs on this site are listed at 5kWh, 8.7kWh and 12kWh. Those three figures are the headline stored-energy values for three distinct models, not three settings of a single model. A buyer comparing them should compare their listed figures on their own product pages, then enquire with the load profile, the solar array size and the inverter limits for a model-specific confirmation.
What to check before enquiring
For a business enquiry, the most useful details are the system voltage, the capacity, the expected discharge current, the operating temperature range and the physical space available. A pack that fits on paper can still fail in use if the discharge current, the temperature range or the terminal layout does not match the application. That is why this site asks buyers to confirm specifications per model, rather than selecting from a generic table.
Depth of discharge describes how much of a pack's capacity is used before it is recharged. Using a smaller depth of discharge generally leaves more cycles available, while deep discharges use more capacity per cycle. Cycle-life figures therefore only make sense with the test condition attached, such as the discharge rate and the capacity remaining at the end of the test. This site reports cycle life per model with its stated condition, and does not convert one model's figure into a range-wide claim.
The inverter is a key check for a solar home system, because the inverter's voltage range, charge settings and cut-off settings must match the pack's listed limits. The listed charge voltage and cut-off voltage on each product page should be checked against the inverter settings, rather than assuming that any home pack works with any inverter. Temperature and placement also matter, because a pack may sit in a garage or a utility room, and the listed temperature ranges on each product page should be checked against that location.
Enquiry checklist
Before sending an enquiry, note the voltage, capacity, quantity, application and any required certification document. State whether the pack will be used indoors or outdoors, and whether a display or a particular terminal type is needed. Minimum order quantity and lead time are unavailable on this site and are confirmed per model in the enquiry. Quotations are confirmed per order.
Send an enquiry | Telephone: +86-755-29040095, +86-18576759460 | Email: michael_he@yabopower.com
Frequently asked questions
How do I get a quotation?
Send an enquiry with the voltage, capacity and quantity you need, plus the application. Quotations are confirmed per order, and specifications are confirmed per model before payment. This site does not list fixed selling figures.
What certification documents can you provide?
ISO 9001 is stated by the company. Certificates are available upon request. If a buyer needs a certificate for a specific model, ask for it in the enquiry and name the model, so the correct document can be checked.
Are the specifications on this page valid for every model?
No. Specifications are shown per model and must not be read across the whole range. Where a value is not listed for a model, the page says to confirm per model rather than filling in a generic figure.